Waste Arms — Installation Instructions

PP16CP

1-1/2" x 15" Waste Drain Tube 15" length

Pp16cp
Recommended procedure for installation -Center outlet installation
  1. To replace or install two waste drain tubes, purchase two Waste Drain Tubes and cut to length with hacksaw, if necessary.
  2. Follow instructions for End Outlet Installation for both arms of tee for either Slip Joint or Direct Connection.

End outlet installation - Direct connection:
  1. Turn off water at tap.
  2. Remove old waste drain tube.
  3. Remove top nut A and washer B.
  4. Invert nut A and drop insert into it.
  5. Attach to strainer using rubber washer.
  6. Put second nut E and poly washer F on insert as illustrated.
  7. Remove nut C and washer D from old tee and tailpiece and place on waste drain tube.
  8. Position waste drain tube. Tighten nuts by hand. Run water to test for leaks.

End outlet installation - Slip joint connection:
  1. Turn off water at tap.
  2. Remove old waste drain tube.
  3. Discard insert and one nut. Put nut A and washer B on strainer tailpiece.
  4. Remove nut C and washer D from old tee and tailpiece and place on waste drain tube.
  5. Position waste drain tube. Tighten nuts securely. Run water to test for leaks.

Installation hint:
  1. Put Teflon® tape on the drain threads before attaching nuts. This will provide a better seal against leaks.
  2. Use a scrap of cloth to protect the chrome finish on the nuts when you tighten with a pipe wrench.
Pipe or Spud Wrench (to remove old brass drain). Teflon® tape Hacksaw