P Traps — Installation Instructions
VNTKTPTRPPVC
Air Admittance Kit with Trap
- Cut wall tube of P-trap to accommodate tee. Note: Tee can be placed at a 45 degree angle and used with the 45 degree elbow to offset the vent in order to clear any obstruction directly above the wall arm.
- Dry fit all of the pieces in place to determine where cuts should be made. Remember to allow for ¾” of the pipe that will be inside the connections. Note: Vent height must be a minimum of 4” from the first ridge on the vent to the top of the wall arm. Cut tubes to length. Note: Pipe that is cut as scrap may be needed to attach the tee to the elbow if offset is being used, do not discard excess pipe.
- Apply pipe thread tape to the threads on the REDI-VENT®. Attach the vent to the tailpiece using the red rubber washer and nut. Hand-tighten only.
- Dry fit all of the pieces to ensure they fit, cut again if necessary.
- Glue all parts in place using all purpose PVC cement.
- Attach J bend to tailpiece and glued assembly.
PVC cutter, PVC cement, tape measure