The J Bend is easy to install to your existing sink drain system. Recommended procedure for installation: P or S type trap:

1. Turn off water at the tap.
2. Remove old J Bend.
3. Remove inlet nut A from new J Bend and select 1-1/4" x 1-1/2" or 1-1/2" washer
4. Place nut A and washer on tailpiece.
5. Put new J Bend into position.
6. Attach nut A and washer and nut B to J Bend as illustrated. Hand tighten. Run water to test for leaks.

1-1/2" IPS sink trap:
NOTE: You may need to purchase a 1-1/2" iron pipe size threaded outlet elbow.

1. Turn off water at the tap.
2. Remove old J Bend.
3. Remove nut A from new J Bend and select 1-1/4" x 1-1/2" or 1-1/2" washer
4. Place nut A and washer on tailpiece.
5. Remove and discard outlet nut and washer from J Bend
6. Attach 1-1/2" Iron Pipe Size Threaded Elbow to J Bend and tighten nut B.
7. Position entire sink trap and hand tighten nut A to J Bend and C to threaded connection. Run water to test for leaks. Note: These parts are designed for a hand-tight installation. Pipe thread compound is not required.

INSTALLATION HINT: Since it "traps" items that may fall into the drain and blocks gases from the waste drain system, water and dirt will be present in the existing trap. Place a bucket under the old trap before attempting to remove it.

Pipe or spud wrench (to remove old brass