Bathroom Accessories — Installation Instructions


Tub and Tile Trim 3/4" x 11

  1. Remove old caulking and clean surface with solvent.
  2. Measure length needed for longer wall section of bathtub enclosure and cut trim.
  3. Peel the back of the adhesive liner about a foot from the end you are starting.
  4. The strip should be pressed firmly against the wall and bathtub to form a tight seal.
  5. Measure and cut length needed for the two shorter wall sections leaving about an inch of
  6. overlap.
  7. Again press firmly against wall and bathtub.
  8. To make certain you have formed a tight seal, run your fingers against entire length of trim.


  • Easily look up and find products
  • Create work lists of favorite products
  • View PDF catalogs and literature
  • Connect with Customer Service