The End Outlet Tee and Tailpiece installs easily for double bowl sinks where the outlet drain is aligned directly under one sink. Recommended Procedure for Installation Slip joint connection:
NOTE: Discard extra nut and insert.

1. Turn off water at the tap.
2. Remove old end outlet tee and tailpiece.
3. Remove top nut A and washer on new tee.
4. Place nut A and poly washer on sink tailpiece as illustrated below.
5. Remove side nut C and washer D and place on waste drain tube.
6. Place nut and washer from J Bend onto tee.
7. Position tee. Tighten nuts securely. Run water to test for leaks.

Recommended Procedure for Installation Direct connection:

1. Turn off water at the tap.
2. Remove old end outlet tee and tailpiece.
3. Remove top nut A and washer B on new tee.
4. Invert nut A and drop insert into it.
5. Attach to strainer using rubber washer.
6. Put second nut E and poly washer F on insert.
7. Put side nut C and washer D on drain tube.
8. Place nut and washer from J Bend onto tee.
9. Position tee. Tighten nuts securely. Run water to test for leaks.

NOTE:For a complete end outlet waste drain installation purchase waste drain tube and follow instructions.
Installation hint: The outlet may be installed directly to the threads of the strainer by using the extra nut and insert provided or by a slip joint connection attaching the tee to the tailpiece which is assembled to the strainer. Match your existing installation.

Pipe or Spud Wrench Thread sealant tape