Continuous Wastes — Installation Instructions

PP923CP

1-1/2" x 16" Continuous Waste End Outlet 16" length

Pp923cp
The End Outlet Waste is for installation in a double bowl sink drain system where the outlet drain is aligned directly under one sink. Recommended procedure for installation Slip joint connection
NOTE: Discard two nuts and the two small inserts.
  1. Turn off water at the tap.
  2. Remove old end outlet waste.
  3. Remove nuts A and washers B from end outlet waste.
  4. Put nuts A and washers B on strainer tailpieces.
  5. Assemble arm to tee.
  6. Place nut and washer from J Bend onto tee.
  7. Place end outlet waste in position. Tighten nuts. Run water to test for leaks. If your sink requires longer arms, purchase Slip Joint Extension Tubes.

Recommended procedure for installation Direct connection
  1. Turn off water at the tap.
  2. Remove old end outlet waste.
  3. Invert nuts A and drop short tailpiece inserts C into them.
  4. Remove nuts D and place on inserts C with poly washer.
  5. Join one insert assembly to the top of the tee and the other insert assembly to the waste arm.
  6. Assemble arm to tee.
  7. Place nut and washer from J Bend onto tailpiece.
  8. Put washers B into top slip nuts. Place end outlet waste in position.
  9. Connect end outlet waste to sink strainers and tighten nuts. Run water to test for leaks. If your sink requires longer arms, purchase Slip Joint Extension Tubes.

Installation hint: The End Outlet Waste may be installed directly to the threads of the strainer by using the extra nut and insert provided (Fig. 2) or by a slip joint connection attaching the tee and arm to the tailpieces which are assembled to the strainers
Pipe or Spud Wrench (to remove old brass outlet tee).
Iphone8_app_screen

KEENEY CATALOG APP

  • Easily look up and find products
  • Create work lists of favorite products
  • View PDF catalogs and literature
  • Connect with Customer Service