Slip Joint or Direct Connection With sanitary baffle tee For double bowl sink Can be used with existing brass system
The End Outlet Waste with Sanitary Baffle Tee is for installation in a double bowl sink drain system where the outlet drain is aligned directly under one sink.
Recommended procedure for installation
Slip joint connection
NOTE: Discard two nuts and the two small inserts.

1. Turn off water at the tap.
2. Remove old end outlet waste.
3. Remove nuts A and washers B from the end outlet waste.
4. Put nuts A and washers B on strainer tailpieces.
5. Place nut and washer from J Bend onto tee.
6. Place end outlet waste in position. Tighten nuts by hand. Run water to test for leaks. If your sink requires longer arms, purchase Slip Joint Extension Tubes.

NOTE: These parts are designed for a hand-tight installation. Pipe thread compound is not required.
Recommended procedure for installation
Direct connection

1. Turn off water at the tap.
2. Remove old end outlet waste.
3. Invert nuts A and drop short tailpiece inserts C into them.
4. Remove nuts D and place on inserts C with poly washer.
5. Join one insert assembly to the top of each tee and the other insert assembly to the waste arm.
6. Place nut and washer from J Bend onto tailpiece.
7. Put washers B into top slip nuts. Place end outlet waste in position.
8. Connect end outlet waste to sink strainers and tighten nuts by hand. Run water to test for leaks. If your sink requires longer arms, purchase Slip Joint Extension Tubes.

NOTE: These parts are designed for a hand-tight installation. Pipe thread compound is not required.
Installation hint: The End Outlet Waste may be installed directly to the threads of the strainer by using the extra nut and insert provided (Fig. 2) or by a slip joint connection attaching the tee to the tailpiece which is assembled to the strainer (Fig. 1). Match your existing installation.

Pipe or Spud Wrench (to remove old brass outlet tee).