S Traps — Installation Instructions

PP943W

1-1/4" S Trap For floor connection slip joint

Pp943w
The S Trap is easy to install as a waste connection between a sink tailpiece and floor outlet.
Instructions:
  1. Turn off water at the tap.
  2. Remove old S Trap.
  3. Remove inlet nut A and washer from the J Bend.
  4. Put nut A and washer on tailpiece.
  5. Loosen nut B.
  6. Put nut C and washer on floor tube. Insert floor tube in connector.
  7. Adjust floor tube and swivel J Bend to align trap into position.
  8. Make sure floor tube does not bottom out in floor fitting.
  9. Hand tighten nuts A, B, and C. Run water to test for leaks.

Note: These parts are designed for a hand-tight installation. Pipe thread compound is not required.
Installation hints:
Since it traps items that may fall into the drain and blocks gases from the waste drain system, water and dirt will be present in the existing trap. Place a bucket under the old trap before attempting to remove it.
Pipe or Spud Wrench PP840-6 Pipe Dope PP854-2 or thread sealant tape PP855-1
Iphone8_app_screen

KEENEY CATALOG APP

  • Easily look up and find products
  • Create work lists of favorite products
  • View PDF catalogs and literature
  • Connect with Customer Service