Bathdrains — Installation Instructions

64PVCPH-8

Bath Drain Triplever Strainer 8" Tube 18" Linkage

Ah209064b
Warning: Parts Engineered to be hand tight!
Instructions:
  1. Connect waste shoe, too, overflow tube and waste plug per diagram to bathtub in normal manner.
    Note: Properly assembled, overflow rube show be vertical and at a right angle to bathtub.
    Note: When drain is properly installed washer will be between waste shoe and tub.
  2. Assemble sponge rubber gasket between tub and overflow flange and insert tub tacks into slots on both sides of overflow to maintain location of overflow and gasket for future assembly of face plate.
  3. To install linkage assembly to the approximate correct length, place plunger on bottom of tub and adjust the length by screwing the eyebolt through hexnut and into clevis until the bottom of the clevis is even to the bottom of the tub overflow hole; then tighten the hexnut against the bottom of the clevis securely.
  4. Install plunger and linkage assembly through overflow elbow. Align face plate with threaded holes in overflow and insert screws.
  5. Test the linkage length adjustment to be sure the plunger reaches the bottom seat to shot off water in its down position and lifts far enough to allow free drainage in its up position.
  6. Screw in strainer into waste plug to complete installation.