Installation:
P or S type trap:

1. Turn off water at the tap.
2. Remove old J Bend.
3. Remove inlet nut A from new J Bend and select 1-1/4" x 1-1/2" or 1-1/2" washer
4. Place nut A and washer on tailpiece.
5. Put new J Bend into position.
6. Attach nut A and washer and nut B to J Bend as illustrated. Hand tighten. Run water to test for leaks.

1-1/2" IPS sink trap:
NOTE: You may need to purchase a 1-1/2" iron pipe size threaded outlet elbow.

1. Turn off water at the tap.
2. Remove old J Bend.
3. Remove nut A from new J Bend and select 1-1/4" x 1-1/2" or 1-1/2" washer
4. Place nut A and washer on tailpiece.
5. Remove and discard outlet nut and washer from J Bend
6. Attach 1-1/2" Iron Pipe Size Threaded Elbow to J Bend and tighten nut B.
7. Position entire sink trap and hand tighten nut A to J Bend and C to threaded connection. Run water to test for leaks.

Note: These parts are designed for a hand-tight installation. Pipe thread compound is not required.
INSTALLATION HINT: Since it "traps" items that may fall into the drain and blocks gases from the waste drain system, water and dirt will be present in the

Pipe or spud wrench (to remove old brass)