Elbows — Installation Instructions


1-1/2" Sink Trap Elbow For sink trap or washing machine drain connection

For solvent weld connection Instructions:
  1. Turn off water at the tap.
  2. Remove sink trap.
  3. Check stub-out from wall. Allow at least 3/4 of stub-out to fit into outlet elbow. If stub-out is too long, cut with hacksaw squarely and clean edges.
  4. Solvent weld elbow to stub-out making sure beveled end with captured nut faces floor.
  5. Place J Bend into position and hand tighten nuts A and D securely.
NOTE: These parts are designed for a hand tight installation. Pipe thread compound is not required.


  • Easily look up and find products
  • Create work lists of favorite products
  • View PDF catalogs and literature
  • Connect with Customer Service