The End Outlet Tee and Tailpiece is for installation in a double bowl sink drain system where the outlet drain is aligned directly under one of the sinks. Recommended procedure for installation
Slip joint connection:
Discard extra nut and short tailpiece insert.

1. Turn off water at the tap.
2. Remove old end outlet tee and tailpiece.
3. Remove top nut A and washer B on new tee.
4. Place nut A and poly washer on sink tailpiece as illustrated.
5. Remove side nut C and washer D and place on waste drain tube.
6. Place nut and washer from J Bend onto tee.
7. Position tee. Hand-tighten nuts. Run water to test for leaks.

Direct connection:

1. Turn off water at the tap.
2. Remove old end outlet tee and tailpiece.
3. Remove top nut A and washer B.
4. Invert nut A and drop insert into it.
5. Attach strainer using rubber washer.
6. Put second nut E and poly washer F on insert.
7. Put side nut C and washer D on waste drain tube.
8. Place nut and washer from J Bend onto tee.
9. Position tee. Hand-tighten nuts. Run water to test for leaks.

NOTE: These parts are designed for a hand-tight installation. Pipe thread compound is not required.
Installation hints: The End Outlet Tee may be installed directly to the threads of the strainer by using the extra nut and insert provided (Fig.2) or by a slip joint connection attaching the tee to the tailpiece which is assembled to the strainer (Fig.1). Match your existing installation. To replace a complete end outlet waste drain installation purchase the 16" End Outlet Style With Sanitary Baffle.

Pipe or Spud Wrench (to remove old brass drain).